Sleeper ends may be arranged to create “panels” or staggered to tie the surface together. A “panel” type installation allows for easier access to the roof surface for maintenance or cleaning later on.

Install sleepers across short dimension of room (or at right angles to the main playing court) 16” O.C. with ends butted and joints staggered a minimum of 24”. Accurately, level and shim sleepers so all …

• Sleepers must be 16” (406 mm) OC maximum spacing. It is recommended a 1/4" (6.4mm) plastic spacer be used between sleepers and subsurface to aid drainage and promote drying. Sleepers …

Another way to install a new radiant oor over an existing oor is to use the sleeper application. This is an alternative to pre-cut/formed “board” type panels for a fraction of the cost... click on this link for …

Install 2x4 sleepers 16” oc, perpendicular to existing joists. Add additional framing for railing posts, cut tiles, & extra sleepers for edge trim, where needed. TIP: Layout the tile design plan before building to …

Note: If sleeper unit does not come off the J-slot screws during closing, grasp No. 2 crosstube shown in illustration and push toward back of sofa. You may need to go to each end and lift unit off.

RDWOOD SYSTEM RezillSleeperTM includes plywood sleepers supported by resilient . ezillTM pads. Plywood sleepers provide resistance to bowing and twisting as commonly associated with softwood …